Xenix & RLL

Larry Dighera root at conexch.UUCP
Sat Nov 5 00:18:30 AEST 1988


In article <3f6dfb02.6bad at apollo.COM> tyager at apollo.COM (Tom Yager) writes:
>I'd like to hear from someone running an RLL/Xenix combination, preferably on
>something like a 20MHz '386 (like mine). All advice will be appreciated.

SCO Xenix supports RLL formatted hard drives.  It isn't even necessary 
to purchase RLL certified drives, as most plated-media drives work
just fine.  Specifically, the Maxtor XT-1085, XT-1140, and Micropolis
1325 operate perfectly when formatted RLL 2-7.  

Consider increasing the performance of your entire hard disk subsystem
further by employing a controller capable of supporting 1:1 interleave.
The Adaptec ACB-2372 will increase an ATs hard disk throughput from
the normal 250 Kb/s to ~750 Kb/s.  The A revision of this controller
runs fine at a 10 Mhz buss speed.

The most inexpensive and fastest 100 MB file system can be implemented
with the above mentioned Adaptec controller and Micropolis drive.  Total
cost should be under ~$700.00 for the hardware.

There are faster and larger options, but this is the most inexpensive
I have found.

-- 
USPS: The Consultants' Exchange, PO Box 12100, Santa Ana, CA  92712
TELE: (714) 842-6348: BBS (N81); (714) 842-5851: Xenix guest account (E71)
UUCP: conexch Any ACU 2400 17148425851 ogin:-""-ogin:-""-ogin: nuucp
UUCP: ...!uunet!turnkey!conexch!root || ...!trwrb!ucla-an!conexch!root



More information about the Comp.unix.xenix mailing list