ttys and multiport cards and SCO 286 2.2.1...
Mitchell Lerner
mitchell at cadovax.UUCP
Tue Mar 29 09:32:58 AEST 1988
I have a problem.
We got a Wyse AT running SCO xenix 286 2.2.1 with a Digiboard
intellegent 8 port card and three Wyse-60 terminals.
The terminals and Xenix are configured to speak at 19.2 KB.
I didn't change anything from the factory configuration on or in the
multiport device or on the terminals, except the baud rate on Xenix
and on the terminals.
the problem:
Sometimes when the terminals aren't in use (user has logged off),
you can't get the login prompt no matter what you try. Use to
be that cycling the power on the terminals would help. Then
we tried just setting-up (cntrl-shift select) to get a login.
Sometimes you'll do all of that and then about a minute later
you'll get the login prompt.
We also grounded the cable's sheilding to the terminal. But
now nothing (not even shutting down the system and bringing it
back up again) will emit a login on this terminal. And it all
seems to happen so randomly...
Seems like the connection is dropped and somthing won't let it
connect again.
These terminals turn their video off after ten minutes of inactivity.
We've also swapped terminals from non-working lines to working ones
and the terminals work fine on these lines.
Could it be that the terminal is sending some sort of hang-up
signal when it isn't supposed to? Or not sending the appropriate
connect signal or dropping DTR and Xenix isn't seeing it rased
or something?
All I know is that the terminals work fine when your logged on.
It's just after you log off and they aren't in use for a while,
they go into this mode where you can't get a login prompt.
Please HELP!
--
Mitchell Lerner
UUCP: {ucbvax,ihnp4,decvax}!trwrb!cadovax!mitchell
"When I fight with my mind, my mind always wins" - Ben Hummel
More information about the Comp.unix.xenix
mailing list